Hard to believe that the trike would run great, and then a month later, will not start at all due to valves not being adjusted correctly. The only thing I haven't checked this time is the valve adjustment. Not sure I can tell a "strong" spark from a weak one, but it is not intermittent. The new plug is gapped properly - 0.65mm.
Yes, it is CDI ignition and the plug gets wet after 8-10 pulls. Check the plug gap.Īnd like mentioned before, make sure the valves are adjusted properly to spec. May not need a new plug.clean the plug with brake cleaner and a fine wire brush, and use some 800 to 1000 grit sandpaper to clean up the gap surfaces between the electrode and electrode tip. This may be a dumb question, but I assume it's CDI ignition and not points? Strong consistent spark, or intermittent? Plug gets "wet"? Getting too much fuel as it is.I would check the carb, clean thoroughly again, checking pilot jet.etc. Ooooooo.since it is "non-running", the for sale price should be really good.wish you were close by!
0 kommentar(er)
